2000 GT problems - info/suggestions wanted
#1
2000 GT problems - info/suggestions wanted
I own a 2000 GT with 5spd with 110,000 miles
Problems-
Front bumper cover/ passenger fog light dented/busted.
Drivers door dented/creased
Passnegers side 1/4 panel rusting.
Fuel filler neck leaking(in shop now)
Only thing every done mechanically is general maintenance and new clutch/starter 1k ago.
Wants -
I'm going to start to rebuild it from ground up as a street strip car with a good suspension, not drag or road race but a good compromise.
Motor wise I want 4.6/stroker with a Procharger or turbo.
I'm looking on advice on where to start and especially best places to buy the sheet metal parts and engine suggestions.
I will also document this over the next year on here if everyone wants.
Thanks in advance.
Problems-
Front bumper cover/ passenger fog light dented/busted.
Drivers door dented/creased
Passnegers side 1/4 panel rusting.
Fuel filler neck leaking(in shop now)
Only thing every done mechanically is general maintenance and new clutch/starter 1k ago.
Wants -
I'm going to start to rebuild it from ground up as a street strip car with a good suspension, not drag or road race but a good compromise.
Motor wise I want 4.6/stroker with a Procharger or turbo.
I'm looking on advice on where to start and especially best places to buy the sheet metal parts and engine suggestions.
I will also document this over the next year on here if everyone wants.
Thanks in advance.
Last edited by NEXT1; 09-06-2009 at 11:53 PM.
Thread
Thread Starter
Forum
Replies
Last Post