shock/strut/caster camber plate ?????
#1
shock/strut/caster camber plate ?????
I purchesed a set of KYB AGX 8 position gas shocks and a set of caster camber plates from upr products. anyone have any install tips.. i am pretty handy but I have never done shocks and struts before. I also have rear upper and lower control arms, will they be easiest to install together! thanks!!! Bob
#2
RE: shock/strut/caster camber plate ?????
struts are not bad to install just make sure you don't let the spring jump out at you. i used to like to do them on the ground and keep a jack under the a-frame.
on the upper and lowers its easier to do them in the air. take the shocks loose then pop the springs out you don't need to compress them. then its just a matter of swapping every thing out make sure you keep the rear supported so you don't damage the break lines.
on the upper and lowers its easier to do them in the air. take the shocks loose then pop the springs out you don't need to compress them. then its just a matter of swapping every thing out make sure you keep the rear supported so you don't damage the break lines.
Thread
Thread Starter
Forum
Replies
Last Post