Modular Powerhouse - Canton, GA
#1
Modular Powerhouse - Canton, GA
Does anyone have any feed back on these guys? They are located very close to me so I was consdering going there for a custom tune, dyno and gear install.
http://www.modularpowerhouse.com/
Also, dyno time and a tune will run about $500 bucks or so but I get to keep the tuner. Am i better off just getting a tune and tuner through brenspeed etc? Will there be a big lift having someone do the tune vs. email etc?
http://www.modularpowerhouse.com/
Also, dyno time and a tune will run about $500 bucks or so but I get to keep the tuner. Am i better off just getting a tune and tuner through brenspeed etc? Will there be a big lift having someone do the tune vs. email etc?
#2
RE: Modular Powerhouse - Canton, GA
Get the SCT2 and tune from Brent. Put the money you'll save toward lca's and lca brackets from him . You'll need them for traction. Then get you some headers. Unless you want to be super quick then get a supercharger.
#4
RE: Modular Powerhouse - Canton, GA
They are very good shop and know there stuff. Basically the programmer is between 380-400 dollars and the time on dyno to dial your tune in for your car is only 100 dollars this sounds like a good deal to me, and a piece of mind knowing your tune is perfect and safe. Plus you will know your car rwhp and rwtq #'s. Canned/custom tunes from the big three tuners are good, but a true dyno tune will squeeze out every bit of your car's potential..
Thread
Thread Starter
Forum
Replies
Last Post
MustangForums Editor
4.6L (1996-2004 Modular) Mustang
3
10-09-2015 03:27 PM
stangin1996gt
4.6L (1996-2004 Modular) Mustang
0
09-21-2015 11:01 AM
tj@steeda
Steeda Autosports
0
09-10-2015 08:39 PM