what would it take to beat a stock GT500?? not planning on going out to find one to race or anything but would be cool just to know that the car is up to par or faster then one..
jus cuz lol.

 

$$$$$

 

A kenne bell running 10 psi...



-John

 

Cold hard cash

 

A new vette.

 

It depends on if the guy with the GT500 can drive. I ran against one twice at the track earlier this year and beat it by 4 tenths both times. The guy just couldn't figure out how to launch it. I asked him if he wanted me to show him how it's done and he told me to "f*ck off". That was a fun day!

 

My GT-500 stock did'nt put up impressive numbers, at the Dyno it was 450rwhp. With that being said after the Cai+2.6 pulley+new plugs+and dyno tune with a 91 and 100octane tune it's putting down 560rwhp on the 91 octane tune, oh I also put in the AFCO Dual pass heat exchanger. The car really comes de-tuned from the factory, mike at silverstate motorsports does all my work. I have some suspension mods I am doing next to help hook up better, so far I have walked a boxster and cayman from a roll at 40mph, they actually pulled me by about 1 car length at the start, but after it hooks up in 3rd gear it was noteven close, I stopped at 130 with about 7 car lengths.

 

You need forced induction to beat one.
I have raced and beat several GT500s and some were modded.

 

That is about right, ~12-15% drivetrain loss puts you alittle over 500hp at the crank.

 

I assume you mean from a roll on the street. In that case it will take nitrous or a blower. You aren't going to need 450rwhp to beat it either because it's allready heavier than you.