Dyno after S/C install
#1
Dyno after S/C install
Finally got my car on a dyno last month after installing the Brenspeed E-Force Stage 1 package. I did the install myself in early November. Went to Fast Lane Performance for the dyno in December. The plan was to do a few pulls on the Brenspeed tune and then update as needed, but they said there was no need to. The output was actually higher than I expected so I am really happy with it. It's been a little over 2 months and 1,000 miles and no problems so far.
#5
It's not really all over the place, look at the scale. The whole run was between 11:1 and 12:1. My air/fuel scale was in 2 point increments and had 8/10/12/14 on the graph so it looked smoother. His is in 1/2 point increments.
#9
Thanks for the comments. It's the Edelbrock E-Force stage 1 package from Brenspeed with the 3.5 pulley on the stock block. Running the brenspeed tune that came with it.
I have heard a lot of good things about Fast Lane Performance here in Houston and they said the A/F was good and I also checked with Dave at brenspeed and he said "I am not impressed with the graphing of the AF. I know our AF is "bang-on" but the graph looks a little goofy to me. I would not be concerned."
It drives great and I have not had one single problem or complaint. Hopefully it stays that way!
I have heard a lot of good things about Fast Lane Performance here in Houston and they said the A/F was good and I also checked with Dave at brenspeed and he said "I am not impressed with the graphing of the AF. I know our AF is "bang-on" but the graph looks a little goofy to me. I would not be concerned."
It drives great and I have not had one single problem or complaint. Hopefully it stays that way!