New guy
Thread Starter
1st Gear Member
Joined: Jun 2007
Posts: 63
From:
New guy
Well, i don't drive a stang but i do love the terminator cars. I have a few friends with 03-04 terminators and quite a few friends with new edge stangs.
Onto my car. It's a 04 350z enthusiast. It's the 6spd with the factory limited slip. It has a vortech s/c with the 3.12 pulley(8.5 psi at redline, sometimes 9), custom intake off the s/c, i/c pipes wrapped in header wrap,walbro 255lph fuel pump, autometer boost gauge, aem wideband,stock bypass valve(bov), test pipes, plenum spacer, custom exhaust, stock clutch and was tuned by sharif at forged performance in marietta,ga. I did all the work to the car, so i could save some money. I've put about 3800 into the car(used s/c kit). Best track time so far is 12.2@115 on street tires at Alabama International Dragway in Steele,Al. The cars last dyno was 390/327 at Walker Dyno Tune in Bham, AL.
Onto my car. It's a 04 350z enthusiast. It's the 6spd with the factory limited slip. It has a vortech s/c with the 3.12 pulley(8.5 psi at redline, sometimes 9), custom intake off the s/c, i/c pipes wrapped in header wrap,walbro 255lph fuel pump, autometer boost gauge, aem wideband,stock bypass valve(bov), test pipes, plenum spacer, custom exhaust, stock clutch and was tuned by sharif at forged performance in marietta,ga. I did all the work to the car, so i could save some money. I've put about 3800 into the car(used s/c kit). Best track time so far is 12.2@115 on street tires at Alabama International Dragway in Steele,Al. The cars last dyno was 390/327 at Walker Dyno Tune in Bham, AL.
Thread
Thread Starter
Forum
Replies
Last Post