New AZ Member
Thread Starter
Joined: Sep 2020
Posts: 3
From: AZ
New AZ Member
Hello to all. Just joined in the hopes of finding information on the Coyote controls pack harness wiring.
Background, I am restomoding a 70 Mach 1. Suspension completely updated with components from Total Control Products. Engine is 2nd Gen Coyote take out from wrecked 2017 GT. Transmission is the 6R80, so some challenges in getting it to fit in the trans tunnel.
The car is a rolling chassis now and I am in the wiring and plumbing phase. I am looking to mount the PCM in the front of the passenger fender well. I want to modify the harness by adding connectors to allow placement of the power distribution box in the interior. Looking for a wire list for the controls pack harness with wire gauge information so that I can select connectors, likely two, to split the harness.
Background, I am restomoding a 70 Mach 1. Suspension completely updated with components from Total Control Products. Engine is 2nd Gen Coyote take out from wrecked 2017 GT. Transmission is the 6R80, so some challenges in getting it to fit in the trans tunnel.
The car is a rolling chassis now and I am in the wiring and plumbing phase. I am looking to mount the PCM in the front of the passenger fender well. I want to modify the harness by adding connectors to allow placement of the power distribution box in the interior. Looking for a wire list for the controls pack harness with wire gauge information so that I can select connectors, likely two, to split the harness.
Thread
Thread Starter
Forum
Replies
Last Post
AntiRiceRacing
5.0L General Discussion
2
Mar 6, 2011 09:50 PM
Korishan
4.6L (1996-2004 Modular) Mustang
0
Oct 11, 2006 10:01 PM