kill and be killed.
i had a few lunch runs with freinds today in my stock s197. 03 mustang gt with 4.10 gears, diablo, o/r x, catback, 75mm tb, plenum, steeda UD, intake, 315 drag radials and a tri ax. the other car was a 06 cobb stage 2 WRX (i didnt ask how much boost)
first run the 03gt ran the wrx from a 15mph roll, i was behind. the wrx jumped out a bit at first then the 03 starts passing, i was on the his *** the whole time. he pulled out a few cars and i passed the wrx and put a full car on him before i let off (so i pulled a total of 3 cars or so since is started so far back) second run i lined up with the 03gt. we went from like a 10mhp roll which i knew was bad for me since he has such a gear advantage with the 4.10s. sure enough he pulled out in first about a car then i stoped the pull but couldnt gain any more ground till we let off at 85-90ish. his back bumper never fully cleared my front.
all in all i am happy, my car is still bone stock down to the paper filter. heck i dont even have synthetic oil yet lol.
first run the 03gt ran the wrx from a 15mph roll, i was behind. the wrx jumped out a bit at first then the 03 starts passing, i was on the his *** the whole time. he pulled out a few cars and i passed the wrx and put a full car on him before i let off (so i pulled a total of 3 cars or so since is started so far back) second run i lined up with the 03gt. we went from like a 10mhp roll which i knew was bad for me since he has such a gear advantage with the 4.10s. sure enough he pulled out in first about a car then i stoped the pull but couldnt gain any more ground till we let off at 85-90ish. his back bumper never fully cleared my front.
all in all i am happy, my car is still bone stock down to the paper filter. heck i dont even have synthetic oil yet lol.
Nice runs Matt.
P.S.: I put the pulleys on and I think it made a bit of a difference. Car seems to pull a little better in the upper RPM range. Gears should finally be here today (they were on back order) and will be going in some time the following week (hopefully).
P.S.: I put the pulleys on and I think it made a bit of a difference. Car seems to pull a little better in the upper RPM range. Gears should finally be here today (they were on back order) and will be going in some time the following week (hopefully).
Thread
Thread Starter
Forum
Replies
Last Post
Matt's 95 Stang
5.0L (1979-1995) Mustang
2
Oct 5, 2015 07:16 AM



