CoBrAbRaT

does anyone know how big of a job this is to install these?

steve

mg01svt

Pretty easy, the tough part would be if you dont have an impact wrench to remove the altenator pulley.

You can use an electric impact wrench from Walmart. From what I can remember the water pump and crank were pretty simple.

whitevenom99

They aren't to bad. If you have a big set of channel locks and a thick rag you can hold the alt pully. If you got a crank pully that you have to replace the whole pully (non piggyback kind) then you are goin to need some grunt to torque it. Also leave the car in gear so you don't turn the motor over.