99 cobra

Sup guys,

OK at 38k my throwout bearing is shot. Its making the dreaded noise. So i need to replace it. I was thinking to buy a stock clutch but i want to upgrade to a lighten flywheel. I need to have this done by next week. Do you guys know any that are good? ITs a 99 cobra by the way. Alot of them exclude the 99 cobra. Please Help.

thanks

99 cobra

callmecobra

why are you going with an alum fly wheel and stock clutch?

fuzi0nz

how bout a steeda tri-ax? just my 2 cents.

99 cobra

Well i have driven a cobra with a stage 2 clutch and i did not like it. And i heard very bad stories about alum flywheels whorping. So i was thinking more of a billet steel or a crome molley. What do you guys think? Also do you guys know a good realiable website (that you have bought from)


99 cobra

callmecobra

just keep the stock one...an aftermarket would prob cost atleast 500 bucks, and its not very beneficial unless you have lots of mods

99 cobra

well i do have some mods. I would like my revs to be quicker though. I was looking at the steeda website and i found billet alum flywheels. and also billet steel flywheels. Which one would you go with? All cobras have the 8 bolt right?

99 cobra

callmecobra

what mods do you have?

99 cobra

i have a 4.10 exhaust intake and others. I will be supercharging in a month or 2. So i went i was looking around and i decided to get a centerforce clutch stage 2 with a steeda billet steel flywheel. Is that a good combo?

99 cobra

mdvaldosta

Yea just stay with the steel, the alum is too light and (especially if you will be going with a cam) will give you some serious idle problems.

fuzi0nz

uh oh. dont let nomo see that yer gonna supercharge yer stang or he'll give you a 5 hour lecture on why u should turbocharge instead jk nomo.