We have a 01 Cobra SVT. The vehicle was lowered with Eibach Spring and a UPR Camber Caster plate installed. When we took it in for an alignment the Tech could not get enough adjustment and waned to redrill the factory mounting holes. We said no called UPR. They said that possibly the units was installed incorectly. Maybe a possibility since there were a lot of hands in the pot and it was well after 1:00am when the work was completing. Has anyone else run into this problem? If so what was the solution? Any good sites with pictures showing the install so we can revisit?

 

I'd call UPR again...make sure installed correctly! ... I've found a lot of problems with UPR stuff as well...

...that's why I use maximum motorsports CC plates!

 

I Installed my 4-bolt MM ones and got a alignment with no problems at all. I think you installed them wrong.

 

MM FTW... and they come in chrome!! thats a +1 in my book

 

of course chrome for you haha but ya mm for me also