2.3T mustang pics
#24
RE: 2.3T mustang pics
i'll try to get some engine pics up this week, its a starion or conquest intercooler, my piping is pretty ghetto and needs to be redone, but its mostly a stock 2.3 setup
ranger roller cam
racerwalsh adj pulley
bailey bpv
magnecor 10mm wires
msd coil
cone filter
ported e6 manifold
ported head (supposedly)
has an n20 setup on it for now but i'm going to convert it back in to an intercooler chiller again
besides the full 3" exhaust thats about it
it also has a spec aluminum flywheel and stage 3 4 puck clutch, and the turbocoupe WC T5 and 8.8 LSD widetrack rearend
ranger roller cam
racerwalsh adj pulley
bailey bpv
magnecor 10mm wires
msd coil
cone filter
ported e6 manifold
ported head (supposedly)
has an n20 setup on it for now but i'm going to convert it back in to an intercooler chiller again
besides the full 3" exhaust thats about it
it also has a spec aluminum flywheel and stage 3 4 puck clutch, and the turbocoupe WC T5 and 8.8 LSD widetrack rearend
#25
RE: 2.3T mustang pics
do you have more info on the aluminum flywheel (like where to get them)? i've been seriously considering one since my clutch is getting pretty ragged, might as well swap them at the same time.
#28
RE: 2.3T mustang pics
ORIGINAL: Jugador
do you have more info on the aluminum flywheel (like where to get them)? i've been seriously considering one since my clutch is getting pretty ragged, might as well swap them at the same time.
do you have more info on the aluminum flywheel (like where to get them)? i've been seriously considering one since my clutch is getting pretty ragged, might as well swap them at the same time.
contact them, they ought to be able to get you a flywheel too, they are cheaper than directly from SPEC but i've dealt with them too and their customer service is amazing
------------------------
what circles? there are the headlights (9007 conversion by the way) and then there are the projectors/foglights