So the windstar intake would flow better than the ported stockie?

 

Depends on the extent of the port I believe. I would think a windstar would flow much better than a simple gasket matched intake however a cut and welded intake I think would be pretty close to the gains of a windstar, but I am not positive just assuming.

 

anyone know how much it would cost me to get a 8.8 rear end for a GT into my sixer?

 

First: downsize your sig pic.

Second: loose those ugly *** rims.

Third: check the 4.0 tech section for your help.

 

thanks for your help...............................

1. if you cant answer my question dont post

2. if i cared what you thought about my rims id ask you......

3. your right about the pic it should be downsized and i will do that :-)

 

LOL....... Looks like mom and dad have some cash lying around... Nice ride

 

learn to number in the order the questions were asked.

Thank you for supporting the stereotype of S197 Sigs.


check the 4.0 section for the swap, where you will most likely catch **** for those wheels as well.

 

i wasnt answering in the order you responeded in but rather in the order of priority


also most people do bang on my rims i know....... i also know if your fine with have the same damn 5 spoke rims that every other mustang has then be my guest (yes i have a set of the cobra r rims) but most people once they see the car in person say the rims grow on them....but like i said i dont care what you think just saying.....


and unlike you ill be semi nice by saying i hope you have the best with your mustang and have it look like what you would like..... plz do not reply to this post as you obvisiouly cannot answer my question.

 

We both answered your question. GO CHECK 4.0 tech. Thats the section for your cars. This is mainly for the SN-95/New edge V6's. And "5 spoke" is pretty broad but I'd take them anyday over your rims. Why don't you do a little searching around in the correct question and I'm sure you'll find your answer. I can't answer your question because I don't know but I tried to steer you in the right direction, so don't tell me don't post if I can't answer your question. Search. And your sig pics still too big.

 

First off, i dont have 5 spoke rims. Mine have 14.

Your car COULD look nice, but theres many glaring problems- the door *****'s, the sideskirts installed OVER the rocker stripe, the paint that doesnt match. I didnt bash on your ride- I was warning you. but you have to take it personally. welcome to the internet, kid.

and I DID answer your question. Observe:

Now id you cant be bothered to read the full post, perhaps you dont ahve the attention span to read full instructions. If you cant learn to read things and comprehend the information that is in front of you, I predict a grand old time when you have to read how to swap a rearend.