cams and heads
05-16-2007, 12:51 AM
1st Gear Member
Thread Starter
Join Date: Jun 2006
Location: Florida
Posts: 125
cams and heads
how much horsepower should i expect from heads and cams?
05-16-2007, 01:03 AM
5th Gear Member
Join Date: Mar 2006
Location: arizona
Posts: 3,893
RE: cams and heads
nobody knows
05-16-2007, 01:09 AM
1st Gear Member
Thread Starter
Join Date: Jun 2006
Location: Florida
Posts: 125
RE: cams and heads
well should i expect a lot or very little
05-16-2007, 01:09 AM
3rd Gear Member
Join Date: Mar 2006
Location:
Posts: 569
RE: cams and heads
To many varibles.........
What lift and duration cams? What will the heads flow? what type of valves being used? Just to name a few..........
You need to decide what your goals are and remember to manage expectations....
Eric
05-16-2007, 01:14 AM
5th Gear Member
Join Date: Mar 2006
Location: CO
Posts: 3,095
RE: cams and heads
right now we thruthfully have almost no clue. there is conflicting data floating around.
05-16-2007, 01:38 AM
1st Gear Member
Thread Starter
Join Date: Jun 2006
Location: Florida
Posts: 125
RE: cams and heads
well ill be sure to let everyone know the results after the purchase/install
05-16-2007, 02:59 AM
2nd Gear Member
Join Date: Oct 2006
Posts: 383
RE: cams and heads
good luck, get us some profile stats and a dyno sheet
05-16-2007, 11:06 AM
1st Gear Member
Join Date: Mar 2007
Posts: 73
RE: cams and heads
I have the X_CH heads and cams, pistons etc. the # are very imprecive.and the low end TQ . Love the set up and the looks.
05-16-2007, 07:23 PM
5th Gear Member
Join Date: Mar 2006
Location: CO
Posts: 3,095
RE: cams and heads
X_CH? wtf is that?
05-16-2007, 07:31 PM
I ♥ Acer
Join Date: Jun 2006
Location: Fort Myers, Florida
Posts: 87
RE: cams and heads
x-charger?