big(ger) guns
#1
big(ger) guns
I dont really give updates on my car here, but I thought I would let people in on what is currently going on with my car. Right now she is in the shop finalizing the installation of:
Spearco Intercooler (http://turboneticsinc.com/products/i...&category_id=9)
Zabteck Throttle Body (http://www.zabteck.com/07tb.htm)
Vortech 12psi Pulley
I am hoping for 320s from my auto on the Mustang Dyno and 340s on the dyno jet. According to the math, I will be looking at around 400hp and 440tq at the crank.
It should all be tuned and done with on Monday next week, so I will post up pictures.
Spearco Intercooler (http://turboneticsinc.com/products/i...&category_id=9)
Zabteck Throttle Body (http://www.zabteck.com/07tb.htm)
Vortech 12psi Pulley
I am hoping for 320s from my auto on the Mustang Dyno and 340s on the dyno jet. According to the math, I will be looking at around 400hp and 440tq at the crank.
It should all be tuned and done with on Monday next week, so I will post up pictures.
#6
RE: big(ger) guns
No, it is all stock (the engine, that is). It seems like the cars can safely take 12psi. I am going to let the tuner decide though, if he says that I am pushing too hard, I will bump it down to 10psi, if he feels that the air-air system is good enough to support more, I may put a bit more the next time I go for a tune (wont be for a few months though). I am the first air-air Vortech so far it seems, so there is no clear limits set in stone.
#7
RE: big(ger) guns
ORIGINAL: chrisc
I dont really give updates on my car here, but I thought I would let people in on what is currently going on with my car. Right now she is in the shop finalizing the installation of:
Spearco Intercooler (http://turboneticsinc.com/products/i...;category_id=9)
Zabteck Throttle Body (http://www.zabteck.com/07tb.htm)
Vortech 12psi Pulley
I am hoping for 320s from my auto on the Mustang Dyno and 340s on the dyno jet. According to the math, I will be looking at around 400hp and 440tq at the crank.
It should all be tuned and done with on Monday next week, so I will post up pictures.
I dont really give updates on my car here, but I thought I would let people in on what is currently going on with my car. Right now she is in the shop finalizing the installation of:
Spearco Intercooler (http://turboneticsinc.com/products/i...;category_id=9)
Zabteck Throttle Body (http://www.zabteck.com/07tb.htm)
Vortech 12psi Pulley
I am hoping for 320s from my auto on the Mustang Dyno and 340s on the dyno jet. According to the math, I will be looking at around 400hp and 440tq at the crank.
It should all be tuned and done with on Monday next week, so I will post up pictures.