351 to 408 in '69 convertible
#1
351 to 408 in '69 convertible
i'm getting my motor this week. stroked to 408, forged rods/pistons, roller cam, edelbrock alum heads [202/190 valves], estimated at 10:1 comp ratio.
Question:
1. the block is from '86 ford p/u--said "h.o." on air cleaner- what kind of bell housing will i need to put tko 600 to it?
2. what clutch and parts are the best for this-will likely use a hyd clutch set up.
3. what can i do for traction help in rear---'69 vert---
4. what can i expect in terms of power? torque and hp?
any other suggestions? i'm taking the car to have the motor/trans installed sometime in nov---need help and some suggestions.
thanks
Question:
1. the block is from '86 ford p/u--said "h.o." on air cleaner- what kind of bell housing will i need to put tko 600 to it?
2. what clutch and parts are the best for this-will likely use a hyd clutch set up.
3. what can i do for traction help in rear---'69 vert---
4. what can i expect in terms of power? torque and hp?
any other suggestions? i'm taking the car to have the motor/trans installed sometime in nov---need help and some suggestions.
thanks
Thread
Thread Starter
Forum
Replies
Last Post