Running Lean
#11
Running Lean
The 80mm is stock MAF housing and electronics from a 98 Cobra that I got off of ebay. 1st I tried rubber elbow from TB to MAF w/ K&N FIPK w/ 95 sensor fuel at 42psi. Then rubber elbow and CAI to the MAF but w/ 98 sensor fuel 36psi...gauge read a shade over 1 volt. Next same setup but fuel down to 33...still gauge a shade over 1V felt like it ran a little better. Tried 30 psi & gauge read the same and still ran strong but wanted to die at idle in gear. Tried the rest of the CAI w/ 98 sensor but felt weaker. Next tried Cobra CAI and MAF felt even weaker (I guess that was too big like you said). Tomorrow I'm going to try the CAI w/ stock MAF housingand clean '95 sensor.
Thread
Thread Starter
Forum
Replies
Last Post