heads, cam, rr's etc and a tune
#21
RE: heads, cam, rr's etc and a tune
Bob-
I went with a set of AFR heads from Keith Craft Racing with 58cc chambers.
These heads have upgraded springs already installed.
http://cgi.ebay.com/ebaymotors/New-S...QQcmdZViewItem
I got Harland Sharp 1.6 roller rockers from Summit.
I went with a custom ground cam from www.flowtechinduction.com.
Unfortunately I havent been able to install these parts yet because I still dont have the car back.
I still have the stock block, crank and pistons and an Edelbrock Performer intake.
I went with a set of AFR heads from Keith Craft Racing with 58cc chambers.
These heads have upgraded springs already installed.
http://cgi.ebay.com/ebaymotors/New-S...QQcmdZViewItem
I got Harland Sharp 1.6 roller rockers from Summit.
I went with a custom ground cam from www.flowtechinduction.com.
Unfortunately I havent been able to install these parts yet because I still dont have the car back.
I still have the stock block, crank and pistons and an Edelbrock Performer intake.
Thread
Thread Starter
Forum
Replies
Last Post
Luke9222
4.6L General Discussion
19
10-22-2015 11:55 PM
MustangForums Editor
Street/Strip
5
09-08-2015 06:25 PM