Jonboy2389

Does it matter?any differences where i should go with one verse the other?

89mustangfive0

i heard the ford racing rockers are good..are you stud mount or pedestal...i just ordered a brand new set of scorpion 1.6 pro race series pedestal mount rockers...i heard alot of people say the crane rockers were noisy

Jonboy2389

ight cool ill prob go with the ford ones, what you run for times with your setup?

89mustangfive0

havent even ran it on a track yet..... its getting tuned in june...i cant wait what set-up are you running

67mustang302

Ford's valvetrain stuff for the Windsor family was made by Crane primarily. Even the 1.7 roller rockers used on the 302 Cobras have a Ford emblem and part number on one side, and "Crane cams" on the other.

Jonboy2389

im about to grab a set of edelbrock aluminum heads ford fcam gt40 upper/lower intake full exhaust no cats bbk equal length headersford hydraulic roller lifters bore 0.030 over 3.73s 16pony wheels bbk cold air intake 70mm throttle body bbk255 fuel pump bbk pulleys and im runnin that on my 89 gt 5.0. might look into chip and bigger injectors too shud be around low 13s high 12s in the quarter.

jtmustang

my cranes seem to be a little noisy so far not to bad but u can hear them with the hood up and standing in front of it but thats about the only time u can hear them

67mustang302

My Cranes are noisy too, like a sewing machine. They've worked so far.

stang8689

You should get 24# injectors, as for a chip stay away from out of the book ones and get one custom burned