ignition switch issues.
#1
ignition switch issues.
So the other day i went to start the car and no lights or anything came on at all, the battery is fully charged and working fine. so i replaced the ignition switch and the lights came on, i put the bezel back together and the lights had gone off, again and when i tried to start it nothing happened. today when i plugged the battery back in the lights came on but very dim, and as soon i turned the key the car went dead again, no instrument panel lights, fuel pump or anything.
#3
how do you tell if its snapped in all the way? i mean i bought the switch and left the little bar on it till i bolted it in, i put it in and bolted it down then took the little metal bar off then connected the harness. is there some other way i was supposed to "snap" it in place?
#4
Theres little tabs on each corner,like a soft metal. Smack them with something to make sure its actually connecting. Had this problem with mine a few years back,turn signals wouldnt work,and if I hit a bump car would shut off,found these tabs werent holding the switch in place. Smacked em down and been good ever since.
Thread
Thread Starter
Forum
Replies
Last Post
lincolnshibuya
V6 (1994-2004) Mustangs
9
12-08-2015 04:37 PM
bradleyb
Classic Mustangs (Tech)
3
11-27-2015 07:50 PM