2010 stereo removal
#1
2010 stereo removal
I have searched I cant find a removal guide for the 2010 base stereo and bezel. I want to install the PAC ipod interface but I need to get behind the radio. Any help is appreciated. Thanks
#2
If its anything like the 2005-09 it doesnt pop out. There are screws.
Not sure if this will work on your 2010.
http://www.youtube.com/watch?v=YXFk6GtzGi0
Not sure if this will work on your 2010.
http://www.youtube.com/watch?v=YXFk6GtzGi0
#3
I dont think its like that thanks for trying though. But the video did help a bit. I pulled up the back of my center console behind the shifter and it popped. Im gonna try to completely disassemble this weekend.
#4
just lift up the center console from around the shifter unplug the harness for the trunk release, hazards, and stability control buttons and set it to the side then remove the 2 8mm screw from the bottom of the bezel and pull on the bezel. its very easy & a hell of alot easier than the 05-09s
#5
just lift up the center console from around the shifter unplug the harness for the trunk release, hazards, and stability control buttons and set it to the side then remove the 2 8mm screw from the bottom of the bezel and pull on the bezel. its very easy & a hell of alot easier than the 05-09s
#6
just lift up the center console from around the shifter unplug the harness for the trunk release, hazards, and stability control buttons and set it to the side then remove the 2 8mm screw from the bottom of the bezel and pull on the bezel. its very easy & a hell of alot easier than the 05-09s
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM