Alcatraz23

Any one know where I can get one of the stripe kits that is the single wide stripe with the two small single stripes on each side. I want the one that goes all the way over the car in white.


Thanks

JimC

It sounds like you are describing the Baltimore Street Mods Shelby Super Stripe -- the only thing missing in my sig is the front bumper stripe so I'm posting some pictures (and since it is a vert, no over the top stripe) - but the front bumper is still not complete:

Alcatraz23

Yes. That is what I am looking for. Do you know where I can get it? I have the yellow 2005 and I want to add them.

mlcrycc

Look over here to the right for the Baltimore Street Mods banner---------------------------------------------------------------------------->



Mike

JimC

Like Mike said the banner is to the right, but in case it doesn't jump out at you: www.baltimorestreetmods.com

Great customer service, Rob will respond to you quickly - I have some replacement vinyl coming for the front bumper because I messed it up. If you do it yourself, expect to take some time, Mike can tell you about his experience. I had mine done professionally (expcept for the front bumper that I decided to do recently) and the pro said the hood was the most difficult he has done because of the compound curves. The front bumper I discovered it tricky as well for the V6 bumper, I got frustrated and then tried to move too quickly and need to fix a couple of spots now and had to order the replacement.

If you do it yourself and decide to do the front bumper, Rob told me that the trick to the lower part on the V6 is to only stick the top part on, let it dry and adhere, and then rewet and stretch the lower part into place. The instructions that I had didn't say that, and I tried to install the full piece at one time.

And expect to have people talk to you once you put this kit on - it seems to attract a lotof attention!

nonstopred

Jim I dont know if its the picture, but that rear bumper stripe looks crooked, I'm not sure though.

JimC

The license plate area is a little off - the stripe on the driver side sits a little bit inside the frame. I've measured though and it is even from side to side on the outside. I've noticed that at certain angles the stripe over the windshield appears crooked, sometimes to the driver and other times to the passenger side, but it also measures dead on and equal from side to side.