157dB

Oh yea, its worth the change. Heat helps remove the pony spoiler.
I had both an 07 pony and a GT spoiler in hand off eBay for cheap,
cheap, ($5 + S/H for the pony spoiler) and test fit both for looks
before applying the 3M tape and picked the wicked looking OEM
GT spoiler, hands down. Much easier to clean under and the 07
pony spoilers ( I keep refering to them as 07 pony spoilers because
the 06 ponys with spoilers just had a GT spoiler installed). And the
07 pony spoilers tend to take off paint from the fenders where they
hover over themon the ends. You must be very careful grasshopper
when removing the 07 pony spoiler. Dont get into a hurry or force it
too much. Slow and steady pressure makes the 3M tape release a
little at a time. The eBay 07 pony take-off I got had the center pieces
of OEM 3M tape still intact like it never took a good hold from
the factory. You migh be as lucky. Also be careful tightening up
the 4 stud/bolts on the new spoiler as you might have metal
deformation around the mounting holes. It does not take much
to hold it on.

socal2fast

What would you go with best for looks the Roush spoiler or GT ? I have a 2007 Pony brand new.

I was thinking of just doing the Roush

Rocker Panels
Rear Wing
window louver kit

And keeping the stcok ft. and rear of the V6 would this look good???? The Roush Rockers Panels will not be lower then the stock ft. and rear parts right?

07 Stang

Wait....did he say Rear Wing???

Of course it is his car and his decision if he wants to mimmack ricers.