thailand

Hello all,
I'm a new member here, and per my introduction, I have always modded my cars. I just bought the GT Concepts plug and play sequentials for my 06 Mustang GT and like to share my experience.
I would have written a DIY, but their instructions on their site are pretty detailed.
With this kit, there is no splicing, no cutting of wires, but you do not get a whole harness. Instead you get a well wrapped circuit board that plugs into your OEM harness inside the trunk. No outside elements to worry about.
One wire has to go through the grommet and plug into the inner most tail light.
Install took me about 45 minutes since I have the Shaker 1000 and the subs are pretty close to the 3 nuts you need to get to in order to get the tailight off.
All in all, the harness fits perfectly and the tail lights look great. At 79.95 shipped, it was one of the less expensive plug and play kits out there. And shipping only took 2 days after I placed my order.
Thumbs up for GT Concepts, and feel free to ask any questions! Thanks for reading.

Tomorrow, my S&B intake install!!!