Hey guys
I was searching the internet today and found and interesting forum where this guy had actually made a "homemade" front splitter. it looks very nice to me. I would very, very, very much so like a front splitter on mine. Here is the problem, I have a 3D Carbon front air dam. So nooooooo body is ganna have one for it
Thats where u guys come in. The guy that made the splitter out of 1/2 inch burch. Made the design and put in on. I am going to start this project and see where it goes. He used wood, should i use plastic? Where could I get some plastic to just cut like that? Thanks guys.
This should be a fun project.

Here is the Forum where it was found: http://forums.evolutionm.net/evo-sho...rty-06-gg.html

 

The top splitter below is made from Sintra a PVC foam board. Worked fine not super strong but I made it so the sheet went all the way back to the radiator support works better that way and is stronger.

The next one is hand laid carbon fiber with a foam and aluminum core. This one weighs more but is many times stronger and I could make it bigger.

 

908, that splitter on the bottom picture looks damn good!

 

that whole car just looks awesome. so awesome i wanna cry..

 

Car looks fast just sitting there... Nice work.

 

Where could I go and pick me up some of these materials?

 

Sintra is available from most plastic dealers and sign shops.

The materials for the carbon spoiler are available lots of places but I don't really advise you to go that way at least not till you have a lot more experience. I have been fabricating stuff in most materials for years carbon as well. Just the materials costs hundreds of dollars to say nothing of the facilities required.

 

that is awesome, wish there was one for the 05-09 body style...looks killer man.

 

I am going to stop by the hardware place after my classes end 2mrw. So, cut it out with cardboard so u get the design? This should be a fun project!

 

http://aprperformance.com/index.php?...=250&Itemid=44