thanks guys, i ordered the 10" with a pin stripe couple mins ago..so they should be here by sat and ill probally install sunday!

 

You'll find out why when you try to put your stripes all over those complex curves on the bumper! Also, it's got a Parnelli Jones vibe to it.

 

I actually saw a black stang with matte black stripes in person and it looked amazing. No pics will do justice. If I ever decide to get stripes, that's the way I am going.

 

Honestly, I don't know how long it'll take, I've never done anything that big. It's just that it's the same thing as putting decals on my R/C car, but on a much larger scale. I'd say you're probably looking at a darn good chunk of the day, though. Also, you'll want to peel back the backing on the vinyl probably no more than... 6 inches? or so at a time, if I were to guess at it. Just go slow. Oh, and make sure your car is nice and spotlessly clean before you begin. One last thing, I'd start with the hood, either right or left side, and then do that entire side of the car before going on to the other, so it'll have plenty of time to dry before you get there. It'd suck to get one stripe one the hood all nice and perfect, then muck it up when you're doing the other side.

 

Every time I see decal installation it always says "DO NOT USE WINDEX!!!"

But I'm no expert...

 

should i use normal soap and water?

 

yes and make sure you use TONS of it if your doing it your self.

 

+ 1

 

hey i have a black gt/cs i was thinkin of doing a single matte black stripe down the middle like the one above..how much does that cost?

 

Where do you get those slats that run across the headlamps?