1/4 mile - 9/30/09
#11
You might want to also look into a once piece aluminum drive-shaft (and maybe a loop too).
This way you can launch at a higher RPM and not have to worry about twisting the stock POS in half. Surprisingly, it doesn't take a lot of power to destroy it. But a hard launch is all it takes.
This way you can launch at a higher RPM and not have to worry about twisting the stock POS in half. Surprisingly, it doesn't take a lot of power to destroy it. But a hard launch is all it takes.
Thread
Thread Starter
Forum
Replies
Last Post
mrmrultimate
Texas Regional Chapter
2
09-10-2015 09:43 AM