SEQUENTIAL PROBLEM
#11
I had the same problem when I installed mine. The guy from Web electric called me, first thing he asked are you testing it without the car running. I told him yes. He said that's problem #1 it needs to be running to put out more than 12 volts. He made me disconnect them, start the car plug back in and put on the 4 way flashers. According to him that's what resets it. He said now keep it running turn off the 4 ways, and try your turn signals while the car is still running. It's been working great ever since. Give it a try. Good luck.
#12
I had the same problem when I installed mine. The guy from Web electric called me, first thing he asked are you testing it without the car running. I told him yes. He said that's problem #1 it needs to be running to put out more than 12 volts. He made me disconnect them, start the car plug back in and put on the 4 way flashers. According to him that's what resets it. He said now keep it running turn off the 4 ways, and try your turn signals while the car is still running. It's been working great ever since. Give it a try. Good luck.
Unless your battery has gone way south...
13.8 Volts typical vehicle running.
A sequential kit that wont work correctly without the engine running?
I dont think so.
Lawerence must have been on drugs with that diagnosis...
#13
When I first installed my kit, 2 of the passenger light would come on, i switched around the bulbs and figured it wasn't the harness but that i needed to replace my current bulbs.
Once I did that, the sequential kit worked perfectly, and the car didn't have to be off.
Once I did that, the sequential kit worked perfectly, and the car didn't have to be off.
Thread
Thread Starter
Forum
Replies
Last Post
Seanam
V6 S197 General Discussion
5
10-04-2015 10:15 AM
tj@steeda
Steeda Autosports
0
10-01-2015 09:11 PM
stangin1996gt
4.6L (1996-2004 Modular) Mustang
0
09-21-2015 11:01 AM