Replace CMCV plates with ProCharger and cams?
#1
Replace CMCV plates with ProCharger and cams?
Ok. I searched so don't get on my case.
I have a P1-SC1 at 10 lbs boost. I have had the CMCV deletes in for a while now.
I have received and am waiting to install a set of Brenspeed Detroit Rocker NA cams.
Question - leave the CMCV deletes in or put the CMCV plates back in?
I have a P1-SC1 at 10 lbs boost. I have had the CMCV deletes in for a while now.
I have received and am waiting to install a set of Brenspeed Detroit Rocker NA cams.
Question - leave the CMCV deletes in or put the CMCV plates back in?
#2
leave them out. they will cause throttle hesitation issues with the blower by themselves. add the cams in, and you are looking at wierd stumbling problems.
I researched it a bit since my 2009 has the damn things integrated with the intake (unlike your 2005 which has them seperate).
there are a few guys running around with centri blowers like yours and the plates still installed. they reported some hesitation and stumbling when in the boost and the plates are doing their thing.
I researched it a bit since my 2009 has the damn things integrated with the intake (unlike your 2005 which has them seperate).
there are a few guys running around with centri blowers like yours and the plates still installed. they reported some hesitation and stumbling when in the boost and the plates are doing their thing.
Thread
Thread Starter
Forum
Replies
Last Post
Dragonus18
4.6L (1996-2004 Modular) Mustang
8
09-09-2015 01:21 AM