URGENT please help - HARD TO SHIFT MANUAL W/Hurst, 2005
#11
Perhaps there's air in the clutch line ... might just need to bleed the clutch. Post #7 in this thread describes the procedure that a shop would perform to bleed the clutch.
http://www.svtperformance.com/forums...ed-clutch.html
http://www.svtperformance.com/forums...ed-clutch.html
#13
i let of VERY slow the car started shaking alot but it didn't stall and i was able to completely let of the clutch
But also ive noticed recently that my clutch feels different before i was able to bring up half way before feeling the "biting point" now if i bring it up more than 25 percent the car starts shaking and feels like it going to stall. I might take it to a different mechanic tomorrow and get a second look at it
But also ive noticed recently that my clutch feels different before i was able to bring up half way before feeling the "biting point" now if i bring it up more than 25 percent the car starts shaking and feels like it going to stall. I might take it to a different mechanic tomorrow and get a second look at it
#14
I recently installed Hurst shifter on my 2007 gt. I have to attempt to put it in first gear for it to go in on a complete stop, this is the same for reverse. But when the car is slowly rolling like a 1-2 mph, it goes right in. What yall think the problem is?
Thread
Thread Starter
Forum
Replies
Last Post
zanemoseley
2005-2014 Mustangs
6
09-06-2015 12:58 PM