Screws For MAF Sensor
#1
Screws For MAF Sensor
Hey can anybody tell me the size of screws i need to install the MAF Sensor into the intake? I just bought a JLT intake and they didnt include them and they havent emailed me back so i take it they dont care.
#3
RE: Screws For MAF Sensor
It said in the instructions anfd in the check list (to make sure u got all the parts) its supposed to have the MAF screws included. And hey for $550 you would think i could get some screws that pry cost a buck.
#4
RE: Screws For MAF Sensor
When was your car made? The only reason why you would need different screws is if your car was made after ford swiched to the self tapping screws. If your car was made before then you should be fine to reuse the same screws.
#5
RE: Screws For MAF Sensor
Many companies are a bit busy and getting back to emails instantly shouldn't be expected. Desired and hoped for, but not expected. If it's longer than a week, only then would I attempt to contact them again.
Have you called them up? Either who you ordered from or JLT. Most companies with good customer support like to keep their customers happy. Word of Mouth sells better than magazine adds. They know this.
Have you called them up? Either who you ordered from or JLT. Most companies with good customer support like to keep their customers happy. Word of Mouth sells better than magazine adds. They know this.
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM
breaking
Audio/Visual Electronics
5
10-02-2015 01:27 PM