mlong54

Just wanted to know how many of you guys have installed your shorty headers and how hard was it?

Xargon321

i did it on mine and it was not hard at all. the bracket the holds the coil will be a pain to put back on because the header flange will be in the way there is holes for the bolts but they will not be long enough reach i would get longer ones.

jimkaray

If you have to ask then I would rate it an intermediate level mod. It isn't to bad but you need a good selection of tools, a floor jack, jack stands and a helper. A mod veteran can do it by themselves. Hope this helps.

4.0 $tang

i did mine last friday by myself....took 3 hours on ride up ramps....definatly use deep wall socket set and "break" the nuts on the cat before you take the bolts off of the stock headers...i also would say a breaker bar is a must have for this install....just my 2 cents

mlong54

Thanks for the replys. The stang is out at my car guy right now getting the headers and dual exhaust put on and I'm going out and rake leafs

mlong54

Well Headers and duals are on and it runs and sounds great. System is JBA headers and exhaust.

Sancho805

same as my setup... i'm very happy with it. i did my install with the help of my bro. could have done it solo but he wanted to lend a hand so i certainly didnt say no

svastano

I will let you know after Saturday! I am going to do the headers and the Pypes duals. at the same time.

mlong54

I have pictures on my profile. So add the pix's. My wife says I'm in my second childhood? I told her I havn't got out of my first one yet!!

ptkthekid

Did the shortys add much power/torqe