One step closer to putting the "CAMMER" motor in!!!!
#1
One step closer to putting the "CAMMER" motor in!!!!
Recieved a new valva train kit from ford racing. Have new valves, high lift springs, retainers and keepers. Now all i need is a sullivan intake manifold and the motor can go in the cobra. Ill get pics up asap
#4
RE: One step closer to putting the "CAMMER" motor in!!!!
As for the engine problem. im going to use an aftermarket short runner intake manifold from sullivan. The reason i needed the computer was to be able to control the butterfly valves inside the cammer intake manifold.
Yeah its pretty much bored to the max but im real confident in it. Steedas new Q575 has a blower on top of a big bore motor so this motor should hold up. i have to rebuild the valve train though because of the mileage this motor has on it
Yeah its pretty much bored to the max but im real confident in it. Steedas new Q575 has a blower on top of a big bore motor so this motor should hold up. i have to rebuild the valve train though because of the mileage this motor has on it
Thread
Thread Starter
Forum
Replies
Last Post
Calizic
4.6L (1996-2004 Modular) Mustang
5
08-28-2015 01:46 PM
HorsePower99
4.6L (1996-2004 Modular) Mustang
1
08-26-2015 11:29 PM