Cobra Question
#21
RE: Cobra Question
now do u actually have any of the engine. and the block is good for 1500 hp stock. the internals on them sn cobras are only good for about 450-500 wheel. and he will need at least that to hit low tens. so it might be a stretch but its quite possible w/ them 4v blocks
#22
RE: Cobra Question
i could see him telling the truth, maybe he put all his money in his engine and didn't have enough to make his hood match the rest of his car...geez that's a horrible body kit on a mustang, it's a shame is a cobra too, if it'd be v6 i wouldn't care.
#23
RE: Cobra Question
haha this is so true
ORIGINAL: silverstang1996
i could see him telling the truth, maybe he put all his money in his engine and didn't have enough to make his hood match the rest of his car...geez that's a horrible body kit on a mustang, it's a shame is a cobra too, if it'd be v6 i wouldn't care.
i could see him telling the truth, maybe he put all his money in his engine and didn't have enough to make his hood match the rest of his car...geez that's a horrible body kit on a mustang, it's a shame is a cobra too, if it'd be v6 i wouldn't care.
#26
RE: Cobra Question
ORIGINAL: Dan04COBRA
Built motor plus slicks + weight reduction. Maybe he ran 10's in the 1/8 since he sounds like a tool.
Ask him what he trapped, find out what his 60' was & his 1/8th. You don't run around on 245 street tires with a 10 second car unless you are a pure butthole & have a death wish.
Built motor plus slicks + weight reduction. Maybe he ran 10's in the 1/8 since he sounds like a tool.
Ask him what he trapped, find out what his 60' was & his 1/8th. You don't run around on 245 street tires with a 10 second car unless you are a pure butthole & have a death wish.
Thread
Thread Starter
Forum
Replies
Last Post
MustangForums Editor
Mustang News, Concepts, Rumors & Discussion
3
11-10-2015 11:39 AM