Stage 2 cams
#1
Stage 2 cams
Ok, I'm about to do a PI swap in about a month and i want to go with stage2 cams. I am going to buy bare heads, and need to know the best place to get the valve springs and stuff for the stage 2 cams?
I've been considering this: http://www.americanmuscle.com/patrio...t-9904-2v.html
I've been considering this: http://www.americanmuscle.com/patrio...t-9904-2v.html
#6
RE: Stage 2 cams
Honestly havent even thought about it, i not sure if i will. I just want a really agressive lope. Anyone know if i will have PTV problems with the stage 2 cams with a npi motor with pi swap?
ORIGINAL: 2000GT4.6
If your going to upgrade the springs comp beehives FTW.
Are you sure you won't have PTV clearance issues with a NPI motor that has a PI swap and the stage 2s?
If your going to upgrade the springs comp beehives FTW.
Are you sure you won't have PTV clearance issues with a NPI motor that has a PI swap and the stage 2s?
#8
RE: Stage 2 cams
Thanks, but what exactly is done to degree cams?
ORIGINAL: phalcrow
You will FOR SURE have PTV problems if you do not get the pistons fly cut OR degree the cams. I did the exact same thing and screwed up all my pistons.
You will FOR SURE have PTV problems if you do not get the pistons fly cut OR degree the cams. I did the exact same thing and screwed up all my pistons.
#9
RE: Stage 2 cams
Not sure, I ended up getting a new shortblock built with fly cut pistons. I know to degree them you need to use a degreeing wheel and a lot of patience. It seemed like too much of a pain in the a$$, plus, I needed new pistons anyway, so I just paid the extra $200 to have the valve reliefs machined in. Somebody else should chime in and give a link on how to degree cams. hint, hint.
Thread
Thread Starter
Forum
Replies
Last Post
jwog666
Pipes, Boost & Juice
11
12-27-2021 08:09 PM
junior04
4.6L (1996-2004 Modular) Mustang
1
09-28-2015 10:53 AM
MustangForums Editor
Mustang News, Concepts, Rumors & Discussion
0
09-25-2015 09:06 AM