Intake Plenum Help

Reply Subscribe

Thread Tools

Search this Thread

Jun 4, 2009 | 09:39 AM

#11

sonicx

Thread Starter

speed'n

Joined: Apr 2009

Posts: 2,248

From: MN

alright

.... sounds like a gr8 product! I'll look into it thanks

Jun 4, 2009 | 11:36 AM

#12

cliffyk

TECH SAVANT

Joined: Dec 2006

Posts: 10,937

From: Saint Augustine, FL

Quote:

Originally Posted by devongarver

I had a conversation a while back with a trickflow rep who swears up and down that pro products is a cheap knockoff and there is no comparison. He said the lack of quality control where pro-products are made is what makes them so poor of a product. But I didn't care much since trickflow was inexpensive and I liked the looks too.

The PP may be a clone, I doubt it though as with their both being US based companies an infringement suit would be a cake walk if were it true. For that matter if you spoke with a Pro Products' rep you might get the same story in reverse?

Nonetheless I have seen them side-by-side and in fact the Pro Products plenum has a bit better (smoother) casting surface and bore then the TF unit. Finer sand, better packed...

You can see this to some extent in the photos.