For my brake kit, I need to pull the rear axle to replace the caliper mounting bracket with the new one (would be nice if the kits came with instructions [:@]). How much work is involved here? Will I need to open the diff and remove its contents? A friend just says there's a couple c-shaped bolts that I need to remove that are near the diff that will then let me pull the axle out, is it that simple? The did this same conversion in 5.0&SF and they mentioned refilling the diff so I can only figure they had to pull everything out of it.

What all am I looking at needing to do to change the caliper mounting bracket?

 

its got not hard to do but you will need to drain the diffy.

 

Open the diff up then what...? I want to know what I'm doing ahead of time so I can get it taken care of as fast as possible, it's about 35 degrees outside so it's not very fun to work in.