How Much Would My Trap Speed Decrease?
6th Gear Member
Joined: Nov 2004
Posts: 7,797
From: Tennessee
get the lakewood control arms , they are bad *** , my friend put them on his o4 cobra with a solid rear and he went from a 1.78 60' to a 1.44 at the same launch rpm...I run a full slick not a dr warming up them evenly is always a problem and think when you take off if one spins then grabs good pop goes an axle.. I run a full slick and 31 spline gear...
I would find that hard to believe a .34 drop off the 60ft was just the control arm's doings.That's pretty drastic. And you aren't gonna be popping any 31 spline axles unless you find a couple hundred HP lying around and throw at to the tires too.
Last edited by ZW99GT; Oct 14, 2008 at 12:19 AM.
1st Gear Member
Joined: May 2008
Posts: 105
From: lubbock TX
those control arms are bad *** and going from irs to a solid rear and a pulley.. sorry i was so vague , oh aNd going from a m/t dr to a full slick ..but a friend of mine in a modded cobra did through down a 1.44 60' with his upgraded irs too...
Thread
Thread Starter
Forum
Replies
Last Post
BeatnikFink
New Member Area
6
Oct 1, 2015 08:00 PM
musnicki
Classic Mustang General Discussion
8
Sep 23, 2015 07:11 AM
