Had a baseline dyno run on the GT today. Wanted to get some numbers before I installed the Vortech. Numbers were ok. I am hoping for some good gains when this is all said and done. Let me know what you think. Mods are in my sig.

Vid
http://www.youtube.com/watch?v=xPmVW6k8moM

Graph

 

good numbers for a bolt-on 2v

 

I was hoping for higher HP numbers, but was impressed with the torque.

 

Very nice numbers mine only put down 233hp and 266ft lb with mac -x/hi-flow cats, flows, 3.73, bbk cai,sct handheld through an auto. those are some nice numbers you put down. good luck with your build. just pulled 339 hp@5550 and 358ft-lbs @4450 on 4lbs of boost with a v1-s trim non ic a/f 11.5. you should put down some nice numbers after that build.

 

I sure hope so. My tuner plans on running 9 lbs of boost so we will see what happens.

 

you should be alot closer to 400 then just make sure you dont go too high on those numbers with those stock internals.

 

good call!

 

I don't expect to be over 400, nor do I really want to be. I am cool with high 300's. This is my DD and need reliability.

 

how much horsepower do you really expect? a FULL bolton 2v will put down in the 260s with a good tune. you arent even full bolton. no headers, no plenum, no tb, no pullies. i'd say your numbers are exactly what should be expected for the mods you have.

will change shortly though. i probably wouldnt have even wanted to see the "before" dyno lol. your about to put it to shame.

 

Very nice man! Looks like those guys have a nice shop. Can't wait to see what she puts down with the blower.