My Recession Buster Engine Build
09-16-2012, 07:11 PM
#61
5th Gear Member
Thread Starter
Join Date: May 2009
Location: kentucky
Posts: 2,241
everything is said and done. the car is on the ground and the interior is in. i just need to get a 4 wheel alignment because of the new k member and rear toe links. then its off to get a tune! heres a pic of the custom seat delete i used
09-17-2012, 09:28 AM
#63
5th Gear Member
Thread Starter
Join Date: May 2009
Location: kentucky
Posts: 2,241
im hoping for 325/325 through a auto but anything over 300 with a strong pull through out the entire rpm range ill be happy. the cams are degreed in at 106 so the rpm range would start lower
09-18-2012, 02:07 PM
#65
5th Gear Member
Thread Starter
Join Date: May 2009
Location: kentucky
Posts: 2,241
im just going to add up the engine build but most of these parts i got lucky on and found good deals
i picked a complete mark viii engine up for 250
new cobra oil pump off corral 35
mmr oil pan and windage tray new on ebay 250 shipped
romeo loaded heads from friend 100
hand head porting 200 plus machining cost
stainless intake valves new from ebay 75
crane valve springs 210
titanium retainer 180
new comp 270 cams from corral 400
hand ported svo intake ebay 200
about 100 in my cai
i had the injectors laying around
steeda crank pully 55
saleen water pump pully 35
on my pypes lt headers, i sold my jba shorties for 255. i only had 30 in them. i bought the pypes for 260 on ebay. so i got 35 in a new set of headers
head swap ford gasket kit 110
i'll say 150 in little extras
on the mark viii, i parted what i didnt use and got 350 from that. so i have around 2000 in what i listed. i have a lot of extras i didnt need but came out good on other things i did.
i picked a complete mark viii engine up for 250
new cobra oil pump off corral 35
mmr oil pan and windage tray new on ebay 250 shipped
romeo loaded heads from friend 100
hand head porting 200 plus machining cost
stainless intake valves new from ebay 75
crane valve springs 210
titanium retainer 180
new comp 270 cams from corral 400
hand ported svo intake ebay 200
about 100 in my cai
i had the injectors laying around
steeda crank pully 55
saleen water pump pully 35
on my pypes lt headers, i sold my jba shorties for 255. i only had 30 in them. i bought the pypes for 260 on ebay. so i got 35 in a new set of headers
head swap ford gasket kit 110
i'll say 150 in little extras
on the mark viii, i parted what i didnt use and got 350 from that. so i have around 2000 in what i listed. i have a lot of extras i didnt need but came out good on other things i did.
