GT500 blower
hello, new to the s197 world. stepping up from my '91 fox... i just bought my parents 05 gt.
Ive seen a few stock blowers off of the 07+ GT500s on ebay for really cheap. will that blower fit on the 3v 4.6? is it a viable mod, or is it a waste of time and money? i do plan to supercharge the car eventually, but i am on a pretty tight budget, student loans, entry level state job with an entry level state salary right now... you know the deal...
the car is a 5 speed, stock 3:31s, 47,000 miles and has the cervinis body kit on it, which i plan on removing due to the fact that, well, i dont like it or the side pipes...
any help would be great.
Ive seen a few stock blowers off of the 07+ GT500s on ebay for really cheap. will that blower fit on the 3v 4.6? is it a viable mod, or is it a waste of time and money? i do plan to supercharge the car eventually, but i am on a pretty tight budget, student loans, entry level state job with an entry level state salary right now... you know the deal...
the car is a 5 speed, stock 3:31s, 47,000 miles and has the cervinis body kit on it, which i plan on removing due to the fact that, well, i dont like it or the side pipes...
any help would be great.
thanks guys. im not looking to make this car too crazy.
just faster than it is...
my mod list plans are as followed
Hurst short throw
California special/shelby GT front bumper
Cali special rear bumper
Cervinis heat extractor hood
Gt500 front brakes
Gt500 rims possibly
Ford racing eaton supercharger kit
hot rod cams
longtubes, xpipe and a flowmaster catback
ford racing handling pack
axle exchange 1 piece drive shaft
max. motorsports control arms and panhard bar
just faster than it is...
my mod list plans are as followed
Hurst short throw
California special/shelby GT front bumper
Cali special rear bumper
Cervinis heat extractor hood
Gt500 front brakes
Gt500 rims possibly
Ford racing eaton supercharger kit
hot rod cams
longtubes, xpipe and a flowmaster catback
ford racing handling pack
axle exchange 1 piece drive shaft
max. motorsports control arms and panhard bar
Actually what was said is not true anymore. There will be a kit that will make it fairly easy and reasonably cheap to put a GT500 blower on the 4.6 3V motor.
Actually what was said is not true anymore. There will be a kit that will make it fairly easy and reasonably cheap to put a GT500 blower on the 4.6 3V motor.
Beat me to it. If you are too lazy to read the thread, there is an adapter being tested right now that allows for a gt500 blower to be used. He is dyno testing it right now, has to get a new clutch since it started slipping around 430tq. When the adapter goes on sale, it will be around $1800. So you can piece together your parts (blower, injectors, intercooler, plugs, stuff like that) and it will can be pretty cheap.
Thread
Thread Starter
Forum
Replies
Last Post




