rayzor_187

Hi

Here comes a question from a frustrated swede.

I have a Mustang -94 GT 5.0 with a strange problem.
It starts up and runs smooth on idle and below 2500 RPM's. but...

As soon as i push it towards 3000 RPM's and above it becomes lame!
No power at all, it take's about 20 sec to rev it up to 5000 RPM's on 2'nd gear with full throttle!!

Also the check engine comes on now and then (have not been able to read out the codes).


Any suggestions??

PX429

keep working with the OBDI

rayzor_187

Are there any good links to where i can buy a OBD I unit or is i any DYI on these things??

92GreyGT

You should make sure that your spout connector is in. It sounds like your timing isn't advancing. Have you or anyone tried bumping the timing?

rayzor_187

OK... two dumb questions from one dumb swede...

What and where are the spout connector?
How do i bump the timing?

... it's soo much easier to fix my stang -70.

// Jimmy from Sweden

92GreyGT

The spout connector is in the wiring that is going to the distributor. It will be hanging somewhere near the wiring harness that's plugged into the distributor. It is just a small plastic grey jumper so to speak. You have to remove that to set your timing. Once you set the timing put it back in. If it's gone your timing won't advance.

PX429

Spout connector is under your MAF

89GTRed

this is your spout pull the plug but dont lose it![]

[IMG]local://upfiles/32142/BBD6E418A8664A848C7DBA04ECAD9DD1.jpg[/IMG]

[IMG]local://upfiles/32142/E4282B6B91ED4AB184E28D3A2FD46A2A.jpg[/IMG]

PX429

it's a 94

89GTRed

oops my bad.