So i took the E7 heads off my old engine because the only thing wrong with it was a blown head gasket. i know i need to get the deck surface milled before they can be reinstalled on another engine but i was wondering if there was anything i could do to get them in better condition with a dremel or something. they need to be cleaned since theres a bunch of sludge on them. also is any of this worth it for these heads?

 

take them bitches to a shop and have em ported then get an intake and strap a turbo on that mamajama.

 

lol no these wont be going into my car. i have a new crate now with aluminum gt40's.
i wanted to work on these heads myself to learn and if i can sell them for a few bucks later.
about porting, is there a good tutorial on that or is that just something a machine can do?

 

oh, nevermind. still throw a turbo on that bitch!

 

there is a dremel port kit you can buy online comes with all kind of misc dremel endsthat you may useand it comes with porting tips booklet. i dont know where i've seen it but its out there. someone here must know where it is.