i pulled two codes and the o2 sensors read it was lean so what do i gotta do now get a fuel regulator and bump up the fuel pressure?

 

thats wut i would do or get a new and bigger fuel pump

 

I would pull the o2 sensors and clean them..if you have a k/n air filter clean the electronics on it..then clear codes...and see what happens..

 

i would clean the code before i buy a AFPR or fuel pump to see if it was just a stored code

 

Had you done any mods before the lean codes came up? Might just be a dirty MAF sensor.

 

depending on your mods you might need a AFPR and need to turn up the fuel pressure

 

lets see here.. clean the electronics on the k&N ... do u mean like the connections on the two sensors? .. if the maf is dirty everyone says not to clean it so what the **** do u do with it ? im gunna clear the codes.. how do u clear them? if they come back then ill clean the **** out of everything.. and get a afpr.

 

Everyone has their own ideas on how to clean the MAF. I used heavy duty brake cleaner (non-residue) and I haven't had any probs. But to each his own. I cleared my codes by unhooking battery for 30 minutes or so.

 

The part to clean is the 2 exposed very fine wires located inside the meter itself.