It's Alive
#1
It's Alive
After 10 months, I finally got my new 347 stroker installed andrunning. My question is this. I have a 5 psi Vortech S trim blower and the person doing the install said he can tune it with a MSD BTM Timing Master because of the low boost. Obviously I could get a chip burned, but he didn't think that was necfessxary. He's got a 93 Mustang that runs 10.30's and has done multiple engine swaps that have includedSC's before, so I trust his opinion. I have a MSD 6AL ignition module and wondered if anyone knew if this piggybacks off the 6AL unit or replaces it.
Also, do you know which Timing Master model I'd need. I know there are a couple different one's out there.
Thanks,
Also, do you know which Timing Master model I'd need. I know there are a couple different one's out there.
Thanks,
#3
RE: It's Alive
Perfect and one last quick question. Is there a specific BTM model I need or would the one I attached here from e-bay work?
http://cgi.ebay.com/ebaymotors/MSD-B...spagenameZWDVW
http://cgi.ebay.com/ebaymotors/MSD-B...spagenameZWDVW
Thread
Thread Starter
Forum
Replies
Last Post