five0fm

right now i have a pair of subfram connecters that came witht he car. they are shorter ones without seat supports. i was planning on making some supports out of angle iron but i would like to know if you guys think i should go full length. right now the car has about 300 horsepower with a supercharged 5.0. im building a 351 that will hopefully produce high 500 low 600hp. im getting the torque arm and panhard bar from maximum motorsports and im wondering if i can stay with the connectors i have now

Ze2222

I'm in the same boat. Sry don't got an answer for u .. Though i'm sure someone will jump in and let u know.

primetime5.0

if you already have the short ones, just use those no point in adding full lengths if you already have subframes on there

ponyboy302

dude if you can custom make the seat supports it definately wouldnt hurt especially with 600 hp thats a lot of twistin goin on