Anybody have a K-member brace?
#1
Anybody have a K-member brace?
I'm looking into getting the MM chassis stiffening package really soon.
My question is does anybody have a k-member brace? If so is it a 2 or 4 point? Do you recommend?
I like autocross more than drag. It takes more skill to overcome a opponent with the physics of turns then just flooring it and bangin gears down a straight track (no offense to hardcore draggers....just being sarcastic[8D]
My question is does anybody have a k-member brace? If so is it a 2 or 4 point? Do you recommend?
I like autocross more than drag. It takes more skill to overcome a opponent with the physics of turns then just flooring it and bangin gears down a straight track (no offense to hardcore draggers....just being sarcastic[8D]
#5
RE: Anybody have a K-member brace?
I have a competition engineering front chasis brace, it is a 4 pt brace that attaches to the rad support, the k-member, and the front subframes, I can do a 90 deg turn at about 80kph.
I also have a strut tower brace, and with both of theese the car handles very good.
I would reccomend both of them.
but it is kinda a beeoch to get the upper intake in without taking the strut brace out.
I also have a strut tower brace, and with both of theese the car handles very good.
I would reccomend both of them.
but it is kinda a beeoch to get the upper intake in without taking the strut brace out.
Thread
Thread Starter
Forum
Replies
Last Post
tj@steeda
Steeda Autosports
0
09-17-2015 07:57 PM
tj@steeda
Steeda Autosports
0
09-16-2015 07:53 PM
tj@steeda
Steeda Autosports
0
09-01-2015 08:16 PM