shaun8850

So I have an older SN series paxton supercharger.. Can anyone tell me if the pulleys that Vortec makes will fit on the input shaft? I want to squeeze just alittle more out. I understand that I dont want to over spin the impeller. Has anyone done this?

Ridinsidewayz

You might try calling vortech they are very helpfull. You could always consider changing the crank pulley to a larger one too. I believe vortech sells larger crank pulleys to produce more boost too.

shaun8850

i can actually get crank pulleys from paxton, but i would have to go 7 rib and by both tryin to save money and stay with a 6 rib, currently have the smallest supercharger pulley and the largest crank in 6 rib....But i seen Vortec makes a 6 rib with a smaller dia....I think i will call vortec thanks!