Fuel pump install issue
#1
Fuel pump install issue
Hey guys, last time I did this I must have got lucky cuz this time. So I did the pump swap all that crap. Now when lowering the pump into the tank I can only get the back side of the collar to sit flat...front side has about a 1/4 inch gap and no matter how I position the stupid thing it wont sit flush....when I back it out a hair and level it out feels like the bottom of the unit is hitting the bottom of the tank? Like the pump assembly is "too long" that type of issue....any of you ran into this when doing yours? Is this a rookie move? LOL thanks all.
#3
RE: Fuel pump install issue
also remember the pump lines should be facing to the driver side.front somewhat.,
there is a black clip and a white one, you cannot interchange them, so after the lines and all are up, start and check for leaks
there is a black clip and a white one, you cannot interchange them, so after the lines and all are up, start and check for leaks
#6
RE: Fuel pump install issue
Im tired.....haha....so much cursing and throwing things...I resorted to yelling at it.....LOL.....I flipped sock around which i guess is the factory location (off a old stock assembly I had) still no dice....Im going to call Ford and yell that the engineer.....guys its not goin this last 1/8 of an inch it needs.....
#7
RE: Fuel pump install issue
ORIGINAL: stanguy306
Im tired.....haha....so much cursing and throwing things...I resorted to yelling at it.....LOL.....I flipped sock around which i guess is the factory location (off a old stock assembly I had) still no dice....Im going to call Ford and yell that the engineer.....guys its not goin this last 1/8 of an inch it needs.....
Im tired.....haha....so much cursing and throwing things...I resorted to yelling at it.....LOL.....I flipped sock around which i guess is the factory location (off a old stock assembly I had) still no dice....Im going to call Ford and yell that the engineer.....guys its not goin this last 1/8 of an inch it needs.....
#8
RE: Fuel pump install issue
Duuuuuuuude you guys ready for this? So I walk over to this other tank I had from a crashed car....and did a test run on that....guess what went right it!!! So Im like WTF? Go back and inspect my tank and it had slight dent in the bottom so pump wouldnt go all the way in? Im like holy fu*k *****....I knew this **** is elementry.....thanks for your help.....Im pissed I burned my whole day but whatever. Its done now....oh and I think I need to take it back out and replace tank cuz when I pounded it out I think I broke that little tube in there....whatever it can sit thats what it gets....LOL
Thread
Thread Starter
Forum
Replies
Last Post
Design1795
Motor Swap Section
1
01-24-2017 10:38 PM
Design1795
New Member Area
6
08-24-2015 04:41 PM