5.0 swap need wiring help!!!
#1
5.0 swap need wiring help!!!
Greetings all, I am in dire need of help. I have just done a 2.3 to 5.0 conversion. I think I may have messed up on my choice for ECM and wiring harness. I swapped a 5.0 out of a 90' LX completewith ECM and engine harness into a 92' 2.3 LX, My problem is that i get basic power to the ignition (lights work, turn signals, Heater fan, etc.) however turning the key to the "On" posistion..the fuel pump does not prime,, then the key over to crank the motor..nothing happens. In addition when I turn my head lights on the horn blows along with the lights turning on. I also lef the original fuel pump in from the 2.3 as well as the wires running to that
Guys I need some serious help on this one!!!
Thanks in advance [/align]
Guys I need some serious help on this one!!!
Thanks in advance [/align]
Thread
Thread Starter
Forum
Replies
Last Post
jaiidutch
Motor Swap Section
2
09-14-2015 10:29 AM